POLTI VAPORELLA BLUE MOON 2.0 Guide De Dépannage page 3

EN
EN
PROBLEM
Water comes out from the
Iron soleplate instead of
steam.
Steam does not come out
from the Iron soleplate.
Little steam comes from
the Iron soleplate.
Traces of water remain on
the garments.
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(see www.polti.com for the updated list) or contact Customer Services.
TROUBLESHOOTING
TROUBLESHOOTING
POSSIBLE CAUSE
The optimal settings for
ironing have been not
reached.
The temperature knob
on the iron is set at the
minimum value.
The boiler has been
overfilled.
No power / On-Off
switch is off.
No water in the boiler.
The steam regulation
knob is set at the
minimum value.
The steam is dry, so is
barely visible, but is
present and effective.
The cover used on
the Ironing board is
wet since it cannot
withstand the power of
the steam station.
3
SOLUTION
Check that the lights are off so that
the temperature and the pressure
have reached the right levels.
Adjust the temperature knob on the
iron to the medium/maximum value.
Push the steam button on the Iron
(directing the steam flow on to a
cloth) till steam comes out from the
holes of the Iron soleplate.
Check that the power is on and that
the On/Off switch is pressed (light
on) (7)
Check whether the low water light is
on (14) and follow the instructions in
Section 6.
Increase the steam flow by adjusting
the steam regulation knob to the
medium/maximum value (10).
This is normal especially in particular
environmental conditions.
Check that the Ironing board is
suitable (ironing board with grid that
prevents condensation).