Publicité
REMOTE CONTROL
1. REC
Press to start/stop recording
2. Led Switch
Press to turn party light on
Press and hold to turn the party light off
3. [
]
Press to start/resume or pause play
4. Volume –/+
Press to increase/decrease volume
5. [
] / [
]
Press to play previous/next track
6. EQ
Press to switch between indoor/outdoor sound modes
7. Mode
Press to switch between the different modes
8. Sound
Press to remove original sound
9. Repeat
Press to repeat single track press twice to repeat all
10. MIC Priority
Press and hold this button to enable or disable microphone priority; the music is automatically turned
down when you speak through the microphone
11. MIC -
Press to decrease volume of the microphone
12. MIC +
Press to increase volume of the microphone
13. Echo –
Press to decrease echo effect of the microphone
14. Echo +
Press to increase echo effect of the microphone
WIRELESS MICROPHONE OPERATION
Press and hold [POWER] to turn the microphone on/off. After the microphone is turned on, the current transmitting channel
(CH A/CH B) is displayed. Press [POWER] a single time to increase the frequency by 500KHz. The receiving speaker will
automatically match the frequency of the microphone. The microphone will turn off automatically after 10 minutes when not in
use.
1. Power
Press and hold to turn the power of the microphone on/off
2. Display
LED display showing frequency, battery status, reception, etc
3. Reset
Carefully press, by inserting a thin tool, to reset the microphone
LINK/STEREO (TWS) PAIRING FUNCTION
When having two Fenton Pulse speaker systems, it's possible to initiate a link (pairing) between the two. Both portable
systems will be emitting the same signal from the streaming audio function. To set up this stereo pairing, please follow the
below steps:
1. Turn on the power on both Fenton Pulse speaker systems
2. Change the operating mode to BT streaming on both Fenton Pulse speaker systems
3. Press [LINK] on any speaker to pair with another speaker to connect. The speaker will give a sound when connection is
completed
4. Press and hold [LINK] to disconnect
The optimal connection distance is about 5 meters.
When re-pairing after shutdown or power down of both speaker systems, the pairing will be "remembered". When setting both
speaker systems to BT streaming mode, they will automatically pair after about 5 seconds.
BT CONNECTION
1. Activate the BT on your device (Mobile phone, tablet etc.) from which you want to play the music
2. See the operating instructions for that device
3. Press the [M] button and activate the BT-function
4. Select "Party Speaker Pulse###" on your BT device and pair
Attention: BT distance is approx. 10 meter without any barrier.
5
Publicité
