Publicité
en-us_main.book.book Page 33 Wednesday, July 31, 2024 2:07 PM
NOTE
• During operation, the function stops if the Water button is pressed. It resumes automatically after 1
hour.
• The function runs automatically for 10 minutes every hour without requiring you to press the Self Care
button.
• UVnano is a compound word derived from the words UV and its unit, a nanometer.
Lock
m
The lock function disables every other button on the display.
• When power is initially connected to the refrigerator, the lock function is off.
• To lock the control panel buttons, press and hold the Lock button until the indicator illuminates and
the function is activated.
• To disable the function, press and hold the Lock button for approximately three seconds.
Full-Convert Drawer
n
Adjust the temperature of the convertible drawer to either colder or warmer than the refrigerator.
Refer to Full-Convert Drawer
• Dispenser Control Panel
Type A
Type A
- Select the desired dispenser mode from the buttons on the dispenser control panel. From left to right,
the icons indicate cubed ice
other container to dispense cubed ice, water or crushed ice.
Type B
- Press the Select button on the dispenser control panel repeatedly to select the desired dispenser
mode. From left to right, the icons indicate cubed ice
dispenser switch with a glass or other container to dispense cubed ice, water or crushed ice.
NOTE
• When the refrigerator is in the Power Saving Mode, the display remains off until a door is opened or a
button is pressed. Once on, the display remains on for 20 seconds.
NOTE
Display Mode and InstaView Display Mode (For Store Use Only)
• The Display Mode disables all cooling in the refrigerator and freezer sections to conserve energy while
on display in a retail store. When activated, OFF is displayed on the control panel and the display remains
on for 20 seconds.
- To deactivate/activate the Display Mode:
Open either refrigerator door. Press the Ice Plus button 3 times while pressing and holding the
Refrigerator button. The control panel beeps and the temperature settings display to confirm that
Display Mode is deactivated. Use the same procedure to activate Display Mode.
TM
TM
in the Operation section.
, water
, and crushed ice
a
b
Type B
. Press the dispenser switch with a glass or
c
, water
, and crushed ice
a
b
OPERATION
33
. Press the
c
Publicité
