Publicité
Read the instructions completely and thoroughly before first use.
- Required tools: Pencil, folding rule, spirit level, drill, stone drill Ø 6, Phillips screwdriver
- Assembly: Before you attach the folding wall table to a solid wall, you should first screw the pre-
drilled table top (1) and the two folding brackets (2) with the 6 short screws (3). Now you can
position the opened folding table at the desired location and align it horizontally using a spirit level.
The 6 drill holes of the two folding brackets are best marked exactly on the wall through the existing
holes; these have a horizontal drilling distance of 55 cm. The positions of the upper drill holes are
determined by your desired height. The middle holes are 5.5 cm lower and the lower holes 12.2 cm
lower. Then the holes with a diameter of 6 mm and a depth of approx. 45 mm are drilled into the
wall. Then the 6 dowels (5) are inserted flush into the clean holes. It is also possible to screw the
wall folding table to sturdy wood without dowels. Now you can easily screw the two brackets
including the table top to the wall with the 6 long screws (4) using a long Phillips screwdriver.
- Assembly time: About 20 minutes
Safety instructions
1. Check the load-bearing capacity of the wall before mounting. The dowels are only suitable for walls
made of concrete or natural stone.
2. Before drilling, please make sure that there are no pipes or lines running in the wall.
3. All holes must be drilled at right angles to the wall and then sucked out or blown out.
4. When using it, always make sure that all screws are firmly tightened.
5. When folding out the table, the two rocker arms of the folding consoles must be fully engaged.
6. The folding table is only intended for material objects and can cause bruising to hands or fingers if
folded up carelessly.
7. Keep a sufficient distance from fire. Fire hazard of the table top due to open flames.
8. The maximum load capacity of the folding wall table is 40 kg distributed over the entire table top.
Keep small parts and packaging material away from children. All individual parts must be checked
for proper functioning before use and never make any changes to the product. Clean the product
with a mild cleaner, so do not use a corrosive cleaner. The product is only suitable for indoor use,
please protect the table top from water. If you are unsure about the type of wall for which the correct
wall plugs and screws must be used, please contact specialist personnel for advice. Keep the
installation instructions for future reference and pass them on to third parties if you pass the product
on. Please dispose of the packaging and all other components properly so that proper recycling can
take place. Thank you very much.
EN
English
3
Publicité
