Publicité
During operation
• Switch off the table base immediately if any unusual occurrences (noises, smoke, fumes, etc.) occur.
Have the table base repaired by a specialist company. Do not switch on the table base again until it
has been repaired.
• Switch off the table base immediately if the safety devices (e.g. up/down switch) do not function properly.
• When operating the sit/stand table, ensure that no objects or body parts can become trapped.
• When adjusting the table base, make sure that nobody is in the vicinity of the table base.
There is a risk of injury.
• Leave the vicinity of the table immediately if it begins to move unintentionally.
Do not operate the table base. Have the table base repaired by a specialist company.
Do not switch on the table base again until it has been repaired.
Control element
1. Sketch
2. Product description
3. Operating instructions
4. Troubleshooting
Description of the buttons: The control panel has two buttons
The table moves upwards
The table moves downwards
Reset
a. Move the table down until it has reached the lowest height.
Then press and hold the
During the reset, the table is lowered a little further, raised again slightly and
then stops.
b. If the lifting system does not respond, release all buttons and then press
and hold the
-button. During the reset, the table is lowered a little further,
raised again slightly and then stops.
c. Height adjustment
Press the
or
-button to adjust the height of the table.
If the table can no longer be moved using the
after the lifting mechanism has been in operation for some time, wait
at least 18 minutes before operating the mechanism again.
-button for 5 seconds to activate reset mode.
and
19
GB
-buttons
Publicité
