CDVI V5SR Mode D'emploi page 7

EN
Installation with Accessories Installation with Accessories
DPM500 - Door position monitoring DPM500 - Door position monitoring
DPM500
Fixed on the magnetic lock
DPM500
Fixed on the armature
Armature plate
7] FAULT FINDING
Problem Possible Cause
Door Door
The lock is not The lock is not
Locking Locking receiving DC receiving DC
impossible impossible current. current.
The lock and the The lock and the
armature are not armature are not
lined up with each lined up with each
Holding Holding other. other.
force force
reduced reduced
Low voltage or Low voltage or
armature jammed. armature jammed.
Faulty Faulty
Reed Reed
Voltage too low. Voltage too low.
switch switch Misalignment Misalignment
All manuals and user guides at all-guides.com
Monitored surface mount Electromagnetic Lock
Roll pin
Solution
- Check that the wires are connected to the - Check that the wires are connected to the
right terminals. right terminals.
- Check that the power supply is compatible. - Check that the power supply is compatible.
- Check that the lock is connected to the circuit - Check that the lock is connected to the circuit
correctly. correctly.
- Check that the lock is connected to the circuit - Check that the lock is connected to the circuit
correctly. correctly.
- Check that the electromagnet and the - Check that the electromagnet and the
armature are properly aligned. armature are properly aligned.
- Check that the contact faces are free from dirt - Check that the contact faces are free from dirt
and rust. and rust.
- Check that the armature is soft mounted. - Check that the armature is soft mounted.
- Check that the lock is receiving the correct - Check that the lock is receiving the correct
power supply satisfactorily. power supply satisfactorily.
- check the tightening of the armature and the - check the tightening of the armature and the
condition of the rubber. condition of the rubber.
- Check the power supply. - Check the power supply.
- Cable cross section to be determined - Cable cross section to be determined
according to the power supply and the locking. according to the power supply and the locking.
- e.g.: 2 x 1.5mm2 ≥ 10m. - e.g.: 2 x 1.5mm2 ≥ 10m.
V5SR
Magnetic Lock
7