Publicité
• Raise the arm by using the tone arm lever.
• Place the stylus vertically over the first track of the record, the turntable will start turning automatically.
• Lower the stylus slowly onto the record by using the tone arm lever.
• When a record comes to the end, the turntable will stop automatically if the auto-stop switch is in the ON position. If the
switch is in the off position then it will keep turning until the switch is set in the ON position.
* Some vinyl records stop before the end or do not stop when the end is reached. In this case set Auto-stop to OFF.
• Lift up the tone arm and put it on the rest when finished, always using the tone arm lever.
• Lock the tone arm by closing the tone arm clip.
• Re-attach the stylus cover.
• Turn off the power.
Before transmission between your BT device and the record player is possible, both devices must be coupled. This process is
called "pairing". The record player is served as a receiver, to receive the music stream to be played on the record player.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in
range and BT operation has been selected on the record player. "Pairing" does not have to be repeated. This function may
need to be activated in your BT device, however.
• Set the mode knob to BT mode.
• Turn on the BT streaming function on your device. The device will scan for pairable BT devices in the reception range.
• Select "Audizio RP112" from the list with found devices.
• You can now play your music from your device, using the turntable player as speaker.
This device also features a BT transmitter, meaning that it is possible to play sound from the turntable player via BT to, for
example, a BT speaker or wireless headphones. Rotate the mode knob to BT OUT mode to enable the BT transmitting function.
Note: When the turntable is being used as a BT speaker, all other playback functions cannot be used at the same time.
You can listen to the music stored in other audio device or smart phone via the record player, through the connection to the
3.5 mm aux-in jack. Use a cable with 3.5 mm pins at both ends, one end connected to the aux-in jack, the other end connected
to the earphone jack on the audio device (or line out socket if available). Play music on the connected device, the sound will
be emitted from the record player.
5
Publicité
