Publicité
Cleaning and Disassembling the PaintStick
9. Remove the roller cover from
the frame.
12. Remove spacer from roller
cover.
Inner handle o-ring
15. Clean roller assembly components in warm water. Lubricate inner handle o-rings, outer end cap, and inner end cap with petroleum jelly.
Put a small amount of petroleum jelly into the fill port.
All manuals and user guides at all-guides.com
10. DO NOT REMOVE INNER END
CAP WITH A SCREWDRIVER!
DAMAGE TO THE INNER END
CAP CAN OCCUR.
13. DO NOT REMOVE OUTER END
CAP WITH A SCREWDRIVER!
DAMAGE TO THE OUTER END
CAP CAN OCCUR.
Outer end cap
PAINTSTICK
®
11. Remove inner end cap from
roller cover by inserting the
frame at an angle into the
inner end cap about 1".
Pull gently towards you to
remove cap.
14. Remove outer end cap from roller cover by inserting the frame inside
the roller cover at a slightly cocked angle. Then gently push to snap
off the outer end cap with the frame.
Optional Method–Remove outer end cap from roller cover using your
fingers.
Inner end cap and seal
5
Fillport
ENGLISH
Publicité
