Publicité
INSTALLATION STEPS
1.1.Installation of single drive rear wheels
1.2.Installation of dual drive rear wheels
1
1
Remove the dirve motor
from the cockpit.
Install the drive motor on the
rear axle on the right side
of the product.
Install an M10 gasket on the
other side of the shaft.
Install one wheel on each
side of the shaft.
Then place an M10 washer
and secure with an M8 nut.
Install the wheel cover
onto the wheel.
Attach the label to the shaft cover.
Remove the 2 dirve motors
from the cockpit.
Install a motor on each
side of the shaft
Install an M10 gasket on the
other side of the shaft.
Install one wheel on each
side of the shaft.
Then place an M10 washer
and secure with an M8 nut.
Install the wheel cover
onto the wheel.
Attach the label to the shaft cover.
4
Publicité
