Publicité
Assembly Instructions
Please keep this owner's manual for future reference
Open the box and inspect the top of the firepit, open the flaps all the way then flip the box over on the top of the
protective sheet.
Step 1. Pull off the carton leaving the top in place. Caution: Do not over tighten the screws until completely assembled.
Step 2. Mount the two sides with the short screws (G) Be sure to mount on eith side of the control knob. Part (E) on
control knob left side, part (F) with window on the right side.
Step 3. Mount the back panel (B) using 4 long screws with washers (H).
Step 4. Mount the do0r panel (C) using the 4 long screws with washers (H).
Step 5. Mount the tank holder (D) with the round part closest to the door using 4 long screws with washers (H).
Step 6. Using 2 people, flip the firepit over and put the lava rocks (A).
Propane Tank & Lava Rocks Installation
Connect the pressure-regulating valve to the
propane tank (Figure E)
Pressure relief
1 - Turn the cylinder valve clockwise to the gas
Cylinder
valve
valve
supply on the propane tank.
Bleed-off
valve
Turn
2 - Screw regulator coupling clockwise (by hand
Regulator
clockwise to
re-seal
only) Make sure it is fastened.
Lava Rock Installation
Keep screen clear. Do not place lava rocks on the
screen (see figure below).
To prevent the flame from being extinguished,
the firepit burner must be completely covered
by the lava rocks (see figure below).
6
Correct
Incorrect
Publicité
