Publicité
USER GUIDELINES
Product overview
1 - USB-C output
2 - EU connector
1
2
Operation
Before use:
The device can be used worldwide due to the supported mains voltage of 100 – 240 volts. Please note
that a country-specific adapter may be necessary.
Before connecting, check whether the connected device is suitable for this power adapter. Pay parti-
cular attention to the required power in the operating manual of the device to be connected and also
observe the instructions given there before using this power adapter.
Information about the power limits of this product can be found in the technical data of this ope-
rating manual.
Make sure that you have followed all the instructions in this manual.
Connecting the device:
Plug a suitable USB cable first into the device to be connected and then into the USB port of this
device. Then plug the power adapter into the mains socket.
The connected device should now be properly powered.
If you are charging a device with a rechargeable battery, disconnect the device from the power supply
again when it is fully charged.
If you are using a product without a battery, disconnect the device from the power supply when it will
not be used for a long period of time.
Attention:
This device supports Power Delivery (PD), PPS and QC for fast charging. No manual settings are
required; the standards automatically negotiate the voltage and power between the devices if the
connected device also supports one of the standards. Due to the large number of different end de-
vices that support these standards, there may be restrictions in the function, especially if the devices
are already older and no longer have the latest software, and the connected device may only be
charged normally.
Please also note that the cable you use must also support the desired fast charging standard and the
higher power output. A 20 V / 3 A cable is required for power outputs up to 60 watts and a 20 V / 5 A
cable for higher power outputs up to 100 watts.
EN - Page 4 of 6
Publicité
