Télécharger Imprimer la page

Buffalo L077 Mode D'emploi page 4

Publicité

UK
Safety Tips
Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any
components on this product.
Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
Ensure the water level is between the 'MIN' and 'MAX' marks.
Always switch off the appliance before removing from the base.
Only use the base supplied with the appliance.
Do not allow the base to become wet.
Danger of scalding - avoid steam from the spout or when opening the lid.
Always switch off and disconnect the power supply to the appliance when not in use.
Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by an BUFFALO agent or a recommended qualified technician in
order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will
provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
BUFFALO Kettle
Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully
functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Operation
Note: Before using the appliance for the first time fill and boil it twice. Discard the water each time.
To use:
1.
Remove the appliance from the base.
2.
Lift the lid and fill with cold water. Do not exceed the 'MAX' level.
3.
Close the lid securely.
4.
Place the appliance on the base.
5.
Connect the base to a mains power supply.
6.
Push the power switch down to the 'I' position. The power indicator light turns On and the water will begin to boil.
7.
When the water has boiled the switch will flick back up to the '0' position. The power indicator light will turn Off.
Note: The boiling process can be interrupted at any time by manually flicking up the switch.
WARNING: There is a danger of scalding from steam. Take care during operation and when opening
the lid.
1

Publicité

loading