Oransi AirMend Manuel D'utilisation

manual
Fan Speed Filter Check
Display Indicator
Getting Started
If the main filter is HEPA go to step 2. For the
1
carbon main filter remove the filter from the
plastic wrap before use. Follow the instructions for
How to Check and Replace the Filter (to the right).
2
Plug the adapter into the back of the machine.
It will power on at medium speed.
Remove the plastic tab from the remote control.
3
Press the + to increase fan speed and – to lower
4
fan speed while pointing the remote at the display.
Lights will turn off after 10 seconds.
Dock the remote on the top of the air purifier.
5
There is a magnet to hold it in place.
Note: AirMend will only operate with an Oransi
filter.
A I R P U R I F I E R
Remote Control Plug-In Power
Docking Station
R EPL A C E ME NT F I L TER S A V A I L A BL E A T O R A NS I .C O M
Adapter
Filter Check Indicator
The red light at the bottom of the fan speed display window
will illuminate in red when it is time to check or replace the
filter.
How to Check and Replace the Filter
Unplug the air purifier. Remove the front cover by pulling
•
at the bottom of the cover away from the machine.
If the HEPA filter media looks dirty or is a gray color it
•
should be replaced. You can vacuum or wash the mesh
pre-filter to remove larger dust particles.
The main filter has to be installed with the side labeled
•
"Bottom" facing down otherwise the machine may not
power on. Place the mesh pre-filter to cover the main
filter.
• Place the front cover back on by pressing in the four
corners. Do not press in the center of the front grill cover.
Plug the air purifier in.
•
To turn off the filter check light point the remote control
•
at the light and press and hold the filter reset button for 4
seconds.
Increase Fan Speed
Power Button
Decrease Fan Speed
Filter Reset
1