Publicité
Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING: This product has been designed for use with the Pfister 15-3WD
(Not included, order separately) series diverter valve. It will not work with any other
product. Please review the 15-3WD series diverter valve installation instructions before
installing this product.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing unit, remove the old unit
and clean the mounting surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Adjustable wrench
• Flashlight
Your installation will require a pipe nipple for the spout installation as well as other
additional tools.
4
E
C
B
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Hand Shower
B Hose
D Drop Elbow
E Screws (x2)
If any of these items are missing, please contact Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Philips head screwdriver
• Cloth
A
F
D
C Wall Mount
F Anchors (x2)
ENGLISH
5
5A
3/4"
5 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (5A) from Wall Mount (5B). Use Wall Mount Screw Holes (5C) to
place the desired location. Using a punch or awl, tap the screw hole locations. Holes
must be vertically aligned.
6
6A
6 ANCHOR INSTALLATION
1
Drill two
/
" Dia. Holes (6A). If installing into a stud, drill two
4
use Anchors (6B). Insert Anchors (6B) into Holes (6A) and tap flush with wall.
7
7C
7 WALL MOUNT INSTALLATION
Place Wall Mount (7A) onto wall and insert Mounting Screws (7B) through Wall Mount
Holes (7C) and tighten until Wall Mount (7A) is flush with the wall. Do Not Over Tighten!
Insert Front Cover (7D) into Wall Mount (7A).
2
5B
5B
5C
1
/
" Dia. holes and do not
8
7C
7A
7B
6B
7B
7D
Publicité
