Kurgo SKYBOX REAR Booster Seat Installation

SKYBOX REAR
DIRECTIONS FOR USE:
1. Unfold the booster seat frame.
3. Connect seat insert flaps to hook and loop fabric.
Position seat insert securely on the bottom of booster.
USING THE TETHER WITH YOUR VEHICLE'S SEAT BELT
1. Pass the seat belt through the handle opening of the tether and attach the carabiner to your
dog's harness leash hook.
OR
1. Remove carabiner and remove the tether from the slide located in the back of the booster
seat. Loop tether around the seatbelt and pull back through tether handle.
2. Pull tether through the slide located in the back of the booster seat.
3. Re-attach carabiner to strap and attach to harness leash hook.
1
WARNING: After clipping the tether strap to a dog harness, adjust the length of the
strap to keep dog from jumping out. Always use a harness with the booster seat,
collars are not suitable for automotive restraint. In the event of an accident the seat-
belt, tether and safety harness will incur the impact while the booster seat frame is
meant to break away. Should an accident occur the booster seat should be replaced.
WASHING INSTRUCTIONS:
NOTICE: Please contact Kurgo directly with any product inquiries.
Kurgo Products 2D Fanaras Drive, Salisbury, MA 01952
•
Instructions and care
Seat Insert
Flaps
OR
Spot clean with a pet-safe detergent. Wipe dry.
2. With the pocket facing the front, rotate padded cushions
toward side walls and secure firmly with hook and loop
fabric strips.
4. Secure booster seat by running seat belt through straps on
the back of the seat. Clip attached tether to your dog's
harness so he stays safely inside.
1
877-847-3868 www.kurgo.com
• •
kurgo.com/product-instructions
Padded Cushions
Car Seat Belt
Seatbelt Straps
2
info@kurgo.com
•
5-16
3