TPL VISION M-HPRING ANGLE CHANGERS Notice D'utilisation

PREAMBLE
This Technical User Guide contains warnings and guidance for correct and safe operation of the product.
These instructions must be followed at all times. TPL Vision will not be held responsible for problems caused
by using the product contrary to these instructions and the Warranty will be deemed invalid.
UNPACKING
Products are packed in our factory, using suitable materials for a safe transport through the usual means of trans-
portation, in France and internationally. However, a damaged package must be reported to the carrier on delivery.
Hand-written reservations must be indicated on the delivery order. Moreover, please send a letter or an email to
TPL Vision as soon as possible (up to 24 hours after the delivery). If the transportation damage has not been stipulated
on the delivery order and reported to TPL Vision in time, the package will not be taken back nor exchanged. To open
the package, do not use any cutting blade to avoid damaging the product(s). Please use the delivered accessories,
if needed (do not use any other products or equivalents to replace the delivered accessories).
DESCRIPTION
Ø
Int.
76
mm
M-HPRING ANGLE CHANGERS
USER GUIDE
The Angle Changer product will MODIFY THE BEAM of your
M-HPRING product. References available:
n AC-HPRING-N n AC-HPRING-N-P1
Narrow beam Narrow beam – Polarised*
n AC-HPRING-M n AC-HPRING-M-P1
Medium beam Medium beam – Polarised*
n AC-HPRING-W n AC-HPRING-W-P1
Wide beam Wide beam – Polarised*
n AC-HPRING-C22 n AC-HPRING-POL1
Convergent beam This Angle Changer does not
change beam angle, but only
polarises* the light source.
* «Polarised» will be marked on product.
PRODUCT CONFIGURATION IS MARKED
ON THE ANGLE CHANGER.
ENG.
HOW TO ATTACH THE ANGLE CHANGER
NOTE : Angle Changers only increase the angle of the light.
Except the converging Angle Changers, they do not focus the light more than the light source.
Angle Changers are only suitable for use with the DT variants of the M-HPRING.
It will not be possible to use the Angle Changers with the DO ringlight models.
+ 44 (0)1738 310 392
M-HPRING ANGLE CHANGERS
USER GUIDE
➊
– Use the magnet to align the Angle
Changer in place on the M-HPRING.
➋
– Angle Changer good for use.
You can turn on the light.
➌
– Use the 3 screws (M2x10) supplied with
the Angle Changers to secure them in place
(recommended for final light installation).
Brenchley House, School Road
Charing, Kent TN27 0JW IS AN
United Kingdom
CERTIFIED MANUFACTURER
www.tpl-vision.com
contact @ tpl-vision.co.uk
ENG.
TPL VISION
I S O 9 0 0 1