Publicité
Liens rapides
Charging
Red LED: Charging
Blue LED: Fully charged
Power On/Off
Power On : Rotate while pressing the Jog dial clockwise for 1 second.
Power Off : Press and Hold the Phone Button and Jog Dial for 5 sec
Volume Adjustment
Increase/Decrease the volume : rotate the Jog dial clockwise/counterclockwise.
Phone Pairing
1. Rotate while pressing the Jog dial clockwise for 5 seconds when the helmet is turned off.
2. By rotating the Jog dial, you will hear the voice prompt, "Phone pairing"
3. Search for Bluetooth devices on your mobile phone.
Select the OUTRUSH in the list of the devices detected on the mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
Music Operation
Play or pause music:Press and Hold the Jog Dial for 1 second.
Track forward/back: Rotate while pressing the Jog dial clockwise/counterclockwise.
Model: SP58
Publicité
Sommaire des Matières pour Sena SP58
- Page 1 Model: SP58 Charging Red LED: Charging Blue LED: Fully charged Power On/Off Power On : Rotate while pressing the Jog dial clockwise for 1 second. Power Off : Press and Hold the Phone Button and Jog Dial for 5 sec Volume Adjustment Increase/Decrease the volume : rotate the Jog dial clockwise/counterclockwise.
- Page 2 Mobile Phone Call Making and Answering Answering/Ending a call: Tap the Jog dial Rejecting a call: Press and Hold the Jog Dial for 1 seconds. Intercom Pairing 1. Rotate while pressing the Jog dial clockwise for 5 seconds when the helmet is turned off. 2.
- Page 3 1. Rotate while pressing the Jog dial clockwise for 5 seconds. 2. By rotating the Jog dial, you will hear the voice prompt, “Factory Reset” 3. Tap the Jog Dial.
- Page 4 Certification and Safety Approvals FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 5 génère et utilise de l’énergie radio fréquence et, s’il n’est pas installé et utilisé conformément. aux instructions, il peut occasionner des interférences nuisibles au niveau des communications radios. Cependant, il n’existe aucune garantie que ces interférences ne se produiront pas dans une installation particulière.
- Page 6 IC RF Exposure Statement Cet équipement est conforme aux limites d'exposition aux radiations de la FCC définies pour un environnement non contrôlé. Les utilisateurs finaux doivent suivre les instructions d'utilisation spécifiques pour satisfaire à la conformité d'exposition RF. L'antenne utilisée pour cet émetteur ne doit pas émettre simultanément avec d'autres antennes ou émetteurs, sauf en conformité...