Publicité
Safety Information
Before Using Your Appliance
Remove all exterior and interior packing.
⚫
Before connecting the appliance to the power source, let it stand upright for
⚫
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system caused by handling during transportation.
Clean the interior surface with warm water using a soft cloth.
⚫
Installation of Your Appliance
The appliances are designed for either built-in, or free-standing installation.
⚫
WARNING: Do not store or install the appliance outdoors.
⚫
Place your appliance on a floor that is strong enough to support it when it is fully
⚫
loaded. To level your appliance, adjust the 4 legs until level.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
⚫
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
Never place the unit in damp areas.
⚫
Plug the appliance into an exclusive, easily accessible electrical socket.
⚫
Any questions concerning power and/or electrical connection should be directed
⚫
towards a qualified electrician or an authorized products service center.
The air vent at the front of the appliance must never be covered or blocked in any
⚫
way.
The appliance must be installed to all electrical connections in accordance with
⚫
state and local codes.
Use two or more people to move and install the wine and beverage cooler. Failure
⚫
to do so can result in back or other injury.
The cooler may experience decreased cooling efficiency if air flow is restricted
⚫
due to a fully loaded cabinet.
Install the wine and beverage cooler in a well-ventilated area where the ambient
⚫
temperature is above 50ºF and below 90ºF.
7
Publicité
