Publicité
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
1. Press
off existing modes.
2. Press
again to return the last modes.
Automatic mode will enable you to run the automatic light programs. To turn on automatic mode:
1. Press
on the remote controller. Display shows
2. Press
or
to choose between the different auto programs.
3. Press
again to turn off the auto mode.
Sound mode will enable the product to respond to the music. To turn on sound mode:
1. Press
on the remote controller.
2. Press
and then press
3. Press
again to turn off the sound mode.
Activate the strobe function in automatic or sound mode .
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of strobe.
3. Press
again to turn off the strobe.
No function
To adjust sound sensitivity for in sound mode.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease sound sensitivity.
3. Press
again to turn off the sensitivity mode.
Select colour gradual change mode.
1. Press
on the remote controller. Display shows
2. Press
or
to either increase or decrease speed of the program.
3. Press
again to turn off the gradual change mode.
Select one of eight static colours.
1. Press
on the remote controller. Display shows
2. Press
or
to choose your static colour.
3. Press
again to turn off the manual mode.
To adjust the fade speed of the automatic program, the sound active program and the manual mode.
1. Press
on the remote controller. Display shows
2. Press
or
to either increase or decrease the speed of the program.
3. Press
again to turn off the fade mode.
1. Select static colour with the buttons
2. Press
or
to either increase or decrease brightness.
.
or
to increase or decrease the sound sensitivity.
.
.
.
or digit
to
.
Publicité
