Publicité
PREPARE THE WINDOW AND INSTALL
5
THE CASE
A
Cut the window sash seal to the proper length .
Peel off the backing and attach the seal to the
underside of the window sash .
Open the window and mark the center of
B
the window sill.
Carefully slide the case into the window
C
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window stool. Mount the case
to the window sill using 2 type B screws.
Drill pilot holes, if necessary.
Stool
Assemble the V-support and V-support
D
bracket with Type F nut and bolt
Left
Sill angle
bracket
V-support Type
F bolt and nut
Installation Instructions
2 type B screws
Type E bolt
and nut
Right
PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
E
Position the V-supports
on the case bottom so
that they will be near
the outside wall. Attach
a V-support to each side
of the bottom of the case
with Type E bolts, 2 for
each support.
Adjust sill angle brackets to rest on sill.
F
Extend the left and right accordion panels
G
to the vertical window sashes. Drill pilot
holes and attach the top corners with 2 type
C screws.
Type C
screw
11
V-support
Sill
Bracket
Type C
screw
Publicité
