Publicité
PART FIGURE
Control Panel
INSTALLATION INSTRUCTIONS
1 Turn the heater body upside down with the bottom facing up.
2 As shown in Figure 1, align the mounting buckles of a set of foot components. The
hole of the heat sink, press in the direction of the arrow, the buckle on the foot. Just
drop into the hole of the heat sink.
3 As shown in Figure 2, align the mounting groove of the foot with the one-way wheel
and Clamped on the second heat sink, the other foot mounting slot is aligned. It is
stuck on the penultimate heat sink. Install it firmly before heating. Place the device
upright and the wheels can be on the ground.
Figure 1
Figure 2
3
Heat Sink Assembly
Caster Assembly
Publicité
