Publicité
Overview
LEVEL
3
1
2
INPUT
ON
SIG
LIM
MONITOR
FOH
6
ON
OFF
8
7
AC VOLTAGE
1. LEVEL
Adjusts the volume level of the input. Turn the control clockwise or counterclockwise to
increase or decrease the input volume.
2. MONITOR/FOH BUTTON
Tailors EQ characteristics to the given application:
Monitor: Select when using as an on-stage monitor, this will also engage the feedback
4
suppressor.
FOH: Select when in use as a full range PA speaker for front of house.
3. INPUT
5
LINK
Line input offers combi XLR & 6.35mm balanced connection.
GND
GND LIFT
4. LINK
XLR output to route the signal to a seperate active speaker.
5. GROUND/LIFT BUTTON
Used to remove unwanted humming noise caused by a ground loop. Cuts the connection
between the earth pin and signal ground to remove the noise.
9
6. POWER SWITCH
Used to turn the speaker on and off. Please Note: Always ensure that the level control is at 0
before switching on your speaker.
7. VOLTAGE SELECT SWITCH
Switch for setting the operating voltage.
Please Note: The mains voltage of your power supply and the operating voltage of the
speaker must be the same.
8. FUSE HOLDER
Secure housing for the fuse which mitigates the risk of fire and damage to the speaker.
Remove this to replace the fuse.
Please Note: Before replacing the fuse, make sure the speaker is turned off and
disconnected from the AC power supply.
9. IEC SOCKET
Plug the power cable supplied into the IEC socket.
5
Publicité
