BST PWA220 Manuel D'utilisation page 16

PWA220
7) HANDHELD WIRELESS MIC DESCRIPTION
8) BELT TRANSMITTER DESCRIPTION
© Copyright LOTRONIC 2018
1. CARTRIDGE
2. SENSITIVITY CONTROL
Adjust input sensitivity of the microphone head, left turn increase, and right turn decrease
3. RF SWITCH
RF power switch, H for high power, L for low power
4. IR PORT
IR port, receives infrared beam to synchronize frequencies with the receiver.
5. BATTERIES SOCKET
Insert two 1.5V batteries (pay attention to the polarity). The operating time is about 8h
6. POWER/ASC INDICATOR
When you turn on the microphone, the indicator lights in green color, if the indicator lights
in red color, this means that the batteries are too low. You must to change for new ones.
During IR transmission is in process the indicator will green flash.
7. POWER/MUTE SWITCH
Use to switch the handheld microphone on/off or mute
1. ANTENNA
2. GAIN AND MUTE SWITCH
There are two gain setting, select the right for your use, "MIC" use with a microphone,
"O" use with a guitar and "-10dB" transmitter mute.
3. ON/OFF ASC LED
When you turn on the microphone, the indicator lights in green color. If the indicator lights
red, that means that the batteries are too low, you must to replace it. During IR
transmission the indicator will flash in green color.
4. MIC INPUT
Connect your microphone headset to this 3 pin input.
5. ON / OFF BUTTON
Tap two seconds to turn on the transmitter, hold to turn off.
6. ASC BUTTON
Press this button to establish infrared connection between the transmitter and receiver.
7. IR WINDOW
This window receives infrared signal from receiver to keep frequency synchronization.
BATTERIES PLACE
Insert two 1.5V batteries ( pay attention to the polarity). The operating time is about
10 hours
WWW.BST-DJ.COM
Page 16