Publicité
Liens rapides
Installation Instructions
5 – Bumpons
8 – Abrasion pads
8 – Mounting clips
8 – Pins
8 – Screws
8 – 'L' Brackets
1 – 48" length "D" gasket
1 – Automotive surface cleaner
1.
Ensure the hood is clean and dry inside and out.
2.
Install the bumpons on the hood as shown in illustration #1 Attention: If bumpons are installed on the protector they will
wear through the paint!!!!
Clean the area indicated in the illustration to a point approximately 24" on each side of the center of the hood.
3.
Center the "D" gasket laterally on the hood. 48" is provided. It may be necessary to trim the length slightly to fit the contours of
4.
the hood.
The "D" gasket installs approximately 1" up from the hood edge. Once its position has been established, peel a small length of
5.
the protective backing and place the gasket in position on the hood. Do not peel the full length of backing off! The adhesive
is very sticky and once it sticks to something it is very difficult to remove. Peel 3 or 4 inches at a time and press down as you
peel.
Hood Protector
HD 5M15
Chevrolet Silverado 2500 2015- up
1 – Phillips Screwdriver # 2
1 – Tape Measure
Publicité
Sommaire des Matières pour FORM FIT HD 5M15
- Page 1 Hood Protector HD 5M15 Installation Instructions Chevrolet Silverado 2500 2015- up 5 – Bumpons 1 – Phillips Screwdriver # 2 8 – Abrasion pads 1 – Tape Measure 8 – Mounting clips 8 – Pins 8 – Screws 8 – ‘L’ Brackets 1 –...
- Page 2 6. Insert a pin through the each of the four (4) holes in the hood protector above the grill and into a mounting clip. See illustration #2 – Step 6. 7. Center the protector on the hood and rest it on the bumpons and mounting clips. 8.
- Page 3 HD 5M15 Protège-capot Instructions d'installation Chevrolet Silverado 2500 2015- up 5 - Bumpons 1 - Tournevis Phillips # 2 8 - plaquettes d'abrasion 1 - Ruban à mesurer 8 - Clips de fixation 8 - Goupilles 8 - Vis 8 - Supports 'L' 1 - 48 pouces joint d'étanchéité...
- Page 4 Introduire une goupille à travers le chacun des quatre (4) des trous dans le capot de protection au-dessus de la grille et dans un clip de fixation. Voir l'illustration # 2 - Etape 6. Centre le protecteur sur le capot et se reposer sur les bumpons et clips de montage. Peel et plier quatre (4) plaquettes d'abrasion dans la moitié...