Publicité
Ignition Switch Module
WARNING:
Never leave a running machine
unattended. Always disengage PTO, move
shift lever into neutral position, set parking
brake, stop engine and remove key to prevent
unintended starting.
To start the engine, insert the key into the ignition
switch and turn clockwise to the START position.
Release the key into the NORMAL MOWING MODE
position once the engine has fired.
To stop the engine, turn the ignition key
counterclockwise to the STOP position. See Figure 8.
Stop
Position
Figure 8
Prior to operating the tractor, refer to both
IMPORTANT:
Safety Interlock Switches, page 14 and Starting The Engine, page
15 of this manual for detailed instructions regarding the
Ignition Switch Module and operating the tractor in
REVERSE CAUTION MODE.
Drive Pedal
The drive pedal is located below
the brake pedal on the right front
side of the tractor along the
running board. Depress the drive
pedal with your right foot when
the tractor shift lever is in either
FORWARD or REVERSE to
cause the tractor to move.
Ground speed is also controlled
with the drive pedal. The further
down the pedal is depressed, the faster the tractor will
travel. The pedal will return to its original position when
it's not depressed.
Always set the parking brake when
IMPORTANT:
leaving the tractor unattended.
All manuals and user guides at all-guides.com
Systems Indicator Monitor
Your tractor is equipped with either an hour meter or an
ammeter as part of two available system indicator
monitors. Locate the monitor on the left side of your
dash panel and compare it to both shown in Figure 9.
Normal
Driving
Mode
Start
Position
If the Brake light or PTO light illuminates when
attempting to start the unit, proceed as follows:
BRAKE —
PTO —
NOTE:
to illuminate while the engine is cranking, but if either
illuminate's while the engine is running, proceed as
follows:
OIL—
BATTERY— The battery is in need of a charge, or the
On units so equipped, the ammeter (if so equipped)
measures the electrical output of the engine's charging
system. Under normal operating conditions, with the
engine at full throttle, the ammeter's needle should
measure a positive charge.
The hour meter (if so equipped) operates whenever
the engine is running and records the actual hours of
tractor operation.
12
AMPS
Ammeter
Battery
+
Hour Meter
PTO
Figure 9
Depress the brake pedal.
Move PTO (Blade Engage) lever,
or PTO (Blade Engage) knob into the
disengaged (OFF) position.
It is normal for the Oil light and the Battery light
Stop the tractor immediately and check
the crankcase oil level as instructed in
the Engine Operator/Owner
Manual included with your tractor.
engine's charging system is not
generating sufficient amperage. Refer to
the MAINTENANCE section of this manual
for the proper battery charging procedure
or have the charging system checked by
an authorized dealer.
Oil
Brake
PTO
Oil
1/10
P
Brake
Publicité
