Connection
Installation
Precautions
• Before installation
Turn the power switch off and disconnect the plug of the display. Disconnect all the plugs connected to the display.
• Before removing, turn the power off with the tuner board's remote control and then turn the main power off.
• When installing or removing the terminal board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the board that could cause unexpected injury.
• When installing the board, fully insert the Board into the slot horizontally until it is firmly plugged into the
connector.
Note that incomplete insertion may damage the internal components.
Compatible slot Nos. are SLOT1 and SLOT2.
Foam mat or thick soft cloth
To remove
Remove the slot cover. Grip the
handle of the terminal board, and
slowly pull out in the direction of
the arrow.
Antenna Connection
For proper reception of VHF/UHF channels, an external antenna is required. For best reception, an outdoor antenna is
recommended. The antenna mode must be set to "TV" (see page 11, SET UP menu-MODE).
VHF Antenna UHF Antenna
Mixer
75 Ω
Ferrite core
(included)
Coaxial
Cable
4
2 slots model
SLOT2
SLOT1
PC
IN
3 slots model
SLOT1
SLOT2
SLOT3
To install
1.Remove the
slot cover.
Securing screw
• Make sure that the Board does not ride on the two lower claws.
• Be sure to fasten all screws tightly.
• Have the customer keep the removed Terminal Board for future servicing needs.
75 Ω VHF/UHF
F-type antenna
adapter (included)
AUDIO
SERIAL
AUDIO
PC
IN
SERIAL
2.Insert the terminal board
until it is firmly plugged
into the connector.
Tighten screws in the
order
1
-
4
.
Note
• To obtain optimum quality picture and sound,
an Antenna, the correct cable (75 Ω coaxial)
and the correct terminating plug are required.
• If a communal Antenna system is used, you
may require the correct connection cable
and plug between the wall Antenna socket
and your television receiver.
• Your local television service center or dealer
may be able to assist you in obtaining the
correct Antenna system for your particular
area and the accessories required.
Ferrite core
• Any matters regarding Antenna installation,
(included)
u p g r a d i n g o f e x i s t i n g s y s t e m s o r
accessories required, and the costs
incurred, are your responsibility.
• Terminal function label
SLOT3 is not
compatible.
3.Affix the terminal
function label
(included).