Télécharger Imprimer la page

KLH Windsor 10 Manuel page 3

Publicité

AVIS WEEE
Note: Cette marque s'applique uniquement aux pays de l'Union eu-
ropéenne (UE) et de la Norvège.
Cet appareil est étiqueté conformément aux normes européennes
Directive 2002/96 / CE concernant les déchets électriques et
équipement électronique (DEEE). Cette étiquette indique que
ce produit ne doit pas être jeté avec les ordures ménagères. Il
devrait être déposé dans une installation appropriée pour per-
mettre la récupération et le recyclage.
UNPACKING
Place the package on the floor or table top with the box flaps up. Cut the
tape with a utility knife to open the package. Fold the carton flaps back
and carefully slide the subwoofer and packaging from the box, or turn the
box over with flaps open and remove the box. Stand the subwoofer and
packing upright, making sure the subwoofer is right side up, and remove
the packing material.
2
1
CONNECTING YOUR
SUBWOOFER
Ensure that the subwoofer is
unplugged from power source
(wall outlet) before making any
connections to your amp/re-
ceiver.
LFE CONNECTION
Connect RCA connector from LFE output on your amp/reciever to LFE
input on subwoofer.
SUBWOOFER
LEFT/RIGHT PREAMP OUT
If there is no LFE output on your amp/receiver, you can use the left and
right preamp outputs to connect to the left and right inputs on your
subwoofer.
L
SUBWOOFER
LINE IN
R
POWER SWITCH/AUTO/ON
The POWER ON switch near the bottom
supplies power to the sub amplifier. When
the AUTO/ON switch is in the AUTO
position, the subwoofer will automatically
turn on when it senses a signal. The sub-
woofer will automatically go into standby
mode after 15 minutes with no signal.
When this switch is in the ON position,
the subwoofer will remain on.
CROSSOVER
This control affects the upper frequency limit of the subwoofer. The
control range is 40-180 Hz, along with a disable (LFE) setting. The slope
of the low pass filter is 12 dB/octave. For connection to an A/V receiver,
the low pass should be set to LFE. For 2-channel applications, it should
be adjusted to blend with the bottom roll-off frequency of your loud-
speakers.
VOLUME CONTROL
This control affects the output of your subwoofer, and should be
set at lowest level before turning the power on. Volume can be
increased until desired level is achieved. For 2-channel applications,
you should adjust the volume to match the output of your speakers.
L
R
PHASE CONTROL
This control delays the signal being processed through the amplifier. For
connection to an A/V receiver, it should be set to 0 degrees. For 2-chan-
nel systems, it should be adjusted to obtain optimal transition between
the loudspeakers and the subwoofer, and best sound stage
3
ROOM POSITION
The placement of your subwoofer can add a significant difference to the
performance of your home theater system. Low frequencies are omni di-
rectional, but best performance results if you place the subwoofer in the
corner, as this will increase the level of bass output. You can experiment
with different configurations, or even add multiple subwoofers to your
system (see diagram).
OPTIONAL
RECEIVER
OUT
NOTE: When cleaning your subwoofer, avoid the use of abrasives,
solvents, or harsh detergents. Windsor subwoofers have a long-lasting
L
vinyl finish that should only require dusting or cleaning with a dry cloth.
PRE-OUT
Gently use the brush attachment of your vacuum cleaner to remove any
RECEIVER
dust or particles from the surfaces of your subwoofer.
R
WARRANTY
Our 5-year parts warranty begins from purchase date of the item (invoice
of the panel
date). For warranty/service issues, please contact your place of purchase.
Please keep your original receipt. The warranty covers any production
and material defects of product. Warranty registration may be complet-
ed at klhaudio.com/warranty
The following is NOT COVERED by the warranty:
MAX
LED
1. Accidents, misuse, poor maintenance, electrical overloads
such as lightning or voltage.
2. Repair must be performed by an authorized KLH dealer or service
center.
3. Incorrect installation of product.
4. Altered serial number.
5. Transportation costs for service call.
6. Purchase of KLH products from unauthorized reseller.
Replacement item cannot exceed the cost of the item under warranty.
The supplier is responsible for only repair or replacement.
FREQUENCY
PHASE
40Hz
160Hz
LEFT
CENTER
SUB
SURROUND
LEFT
OPTIONAL
SUB
LEVEL
180°
MIN
MAX
RIGHT
SUB
SURROUND
RIGHT
OPTIONAL
SUB

Publicité

loading

Ce manuel est également adapté pour:

Windsor 12