Publicité
1. HYDRATE ROUNDS
Open 1 packet and pour rounds into container
of clean tap water. It is recommended to use
at least 0.5 gallon/2 liters of water per 5,000
rounds. If you want to hydrate only some of
the rounds in a packet and save some rounds
for later, use the same amount of water.
More water than recommended will not impact
hydration: It is not possible to overhydrate the
rounds or grow them too large to function in
the blaster.
Make sure rounds are fully submerged in
water.
Allow rounds
to remain in
container
for about
3-4
hours to be
fully hydrated.
HOURS
ROUND STORAGE
Discard any unused hydrated rounds.
F76320920_INST_NER_23_EN_PC1_FAR.indd 4-5
F76320920_INST_NER_23_EN_PC1_FAR.indd 4-5
2. ASSEMBLY
PRIMING BOLT
Attaches to either side for right-handed or left-handed battlers.
Turn clockwise to attach and counterclockwise to remove.
BOOST BARREL
Attach barrel to optimize the blaster for distance targeting.
The blaster can be fired without the boost barrel.
ATTACH
REMOVE
HOURS
2
1
3. LOAD HOPPER
Open hopper door.
Load up to 100 rounds into hopper. Hopper
has 100-round capacity.
Close door.
Make sure door is securely closed.
4. FIRE
Wear the included protective eyewear when you or
anyone else nearby is using a Nerf Pro Gelfire blaster.
Unlock trigger
Pull priming bolt all the way back and push it all the
way forward.
Pull trigger to fire 1 round.
15/03/23 11:58
15/03/23 11:58
Publicité
