Publicité
ENGLISH
Transmitters enable the user to control one or more motors with receiver, installed on
awnings, shutters and screens.
The radio signal is shown by the transmission LED. If the LED doesn't blink after the button
pressure, then the battery has to be replaced.
PLEASE NOTE: do not use motors with remote controls in areas with risks of radio di-
sturbs over the norm (i.e. airports or radio repeaters). These units may also be disturbed
by telecommunication and/or transceiver systems with the same frequency.
PROGRAMMING TRANSMITTER (Fig. 1)
CAUTION: If more motors with receiver have to be installed, it is important to power up
only one motor at time during the first programming session, in order to avoid any interfe-
rences with the others.
1. Power up the motor to be programmed.
2. Hold PROG-TX pressed until the motor starts moving.
3. Check the rotation of the motor, then release PROG-TX (the motor stops).
4. Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or
DOWN if vice versa).
In this way the transmitter has been programmed and the rotation of the motor has been
syncronized.
ADDING TRANSMITTER
1. Hold PROG-TX pressed of a transmitter already paired until the motor starts moving.
2. Check the rotation of the motor, then release PROG-TX (the motor stops).
3. Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or
DOWN if vice versa) on the new transmitter being added.
Additional transmitter is now added
CHECKING/CHANGING DIRECTION (Fig.2)
1. Press UP or DOWN the motor should go UP or DOWN, otherwise to change direction:
2. Press and hold PROG-TX button till the motor starts moving.
3. Press STOP: The motor makes a brief jog.
Direction of the motor has been reversed.
ERASING TRANSMITTERS
Push simultanously PROG-TX and STOP of the transmitter until the motor makes a brief
movement in both directions.
Only the transmitter used for this procedure has been deleted from motor memory
RESET TRANSMITTER MEMORY (DELETING ALL THE TRANSMITTERS OR CHANNELS OR
SENSORS)
Option 1 (Fig. 3.1)
Using an already programmed transmitter press and hold both PROG-TX and STOP buttons
till the motor makes first a brief jog and, after a while, a second long jog. Memory is now
empty.
Publicité
