Powerplus POWX3000 Traduction Du Mode D'emploi D'origine page 22

7 ASSEMBLY
Attention !Check if the power plug is disconnected from the mains
▪ Unfasten the lock tabs '(2) on the vacuum container (1)
▪
Lift the cover (4) off
▪
Check if the filter (10) is assembled well
▪
Place the cover back over the container and fasten with the lock tabs.
▪
Connect the aluminium nozzle (8) with the suction hose (7) to the suction hole (9) at the
container.
▪
Connect the ash vacuum cleaner to the mains and switch on.
▪
You can now clean the stove, fireplace or barbecue by using the nozzle. If the nozzle
becomes blocked by a piece of charcoal or similar, switch off the ash vacuum cleaner.
Carefully tap the nozzle against the inside of the stove or fireplace to remove the object.
Note: Before use the ash vacuum, make sure all connectors and the dust
filter subassembly (10) is tightly fastened. The container and dust filter
must be completely dry.
8 OPERATION
▪
Before you start the appliance, make sure that the filter is in the position.
▪
Unwind the power cord.
▪
Plug the appliance and switch on.
▪
Unplug the appliance after use
≤40℃!!! For use with cold ashes only!
9 CLEANING AND MAINTENANCE
Clean the filter before/after each use
▪
If the suction strength deteriorates during use, turn off the ash vacuum cleaner.
▪
As soon as the suction force reduces, empty the contents of the container.
▪
Remove the suction hose (7) and loosen the cover with the lock tabs.
▪
Hold the dust filter and loosen by hand
▪
Clean the filter by shaking off the ash
▪
Assemble the vacuum cleaner
Caution: Do not use cleaning agents to clean the plastic parts of the tool. A
mild detergent on a damp cloth is recommended. Water must never come
into contact with the tool.
Copyright © 2024 VARO
POWX3000
P a g e | 5
EN
www.varo.com