Publicité
[UK] Electronic water timer manual
Kinzo garden
Item no: 871125214829
Model no: YL22077i
This automatic watering irrigation controller has a built-in membrane pump, and the watering frequency
can be set to between 1 hour and 7 days. The run time can be set to between 1 minute and 120 minutes.
Cut the enclosed tube to your liking for the watering distance and connect the drip irrigation system to the
tube then place them in the flower pots. Up to 10-15 flower pots can be set up with one system.
Item specification:
Water suction height: < 2 metres
Max. distance between water source and drip system: < 5 metres
Irrigation flow rate: 250 ml per minute
Operation
1. Put the required batteries in the item (3x AA, not included).
2. Connect the tubes to the inlet and outlet of the controller, making sure that the inlet end is connected to
the filter and the outlet end is connected to the 3-way anti-siphon connector.
3. Set the desired programme, Frequency can be used to set a regular time between waterings. Note:
Frequency must be set to a value higher than the Run Time, otherwise the setting will be cancelled.
4. Set delay function: Here is an example if you want to set the Frequency to 1 day, irrigation to 5 min. and
the watering start time to 18:00 but have a current clock time of 9:00. Press the Delay button for more than
2 sec. until the LED is ON, then release the Delay button so that from now on each press of the Delay
button will add a 1 hour delay. In this case you need to press the Delay button 9 times to create a 9 hour
delay. Delay time can be set to between 0 and 23 hours. If the Frequency is changed to another value in
any situation, the next watering start time is also changed. Changing the Run Time will not change the next
watering start time.
5. In normal working situations, the LED will blink every 4 seconds, which means that all settings are
working properly. When the LED blinks very quickly, it means the battery is low and you should replace the
batteries with new ones. When the batteries are low, the controller will shut down and the watering
programme will stop working.
Publicité
