Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION:
Congratulations on your purchase of a Gemini product. Your product
is a state of the art unit, backed by a 1 year limited warranty. With the
proper care and maintenance, your unit will provide years of reliable
service. Please register your product online at htip://www.geminid;.
com or using the included form at the end of this manual.
CAUTIONS:
b
- All operating instructions should be read before using this equipment.
2. To reduce the risk of electrical shock, do not open the unit. There are
NO USER REPLACEABLE PARTS INSIDE. Please refer servicing to a
qualified service technician.
3. Do not expose this unit to direct sunlight or to a heat source such as a
radiator or stove.
4. This unit should be cleaned oniy with a damp cioth. Avoid sotvents or
other cleaning detergents,
6. DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
7. DO NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY
CONTROLS OR SWITCHES.
CONNECTION.
OPERATION:
5. MIC JACK:
1/4" microphone input jack (5).
6. VOLUME:
Overall volume is controlled by the VOLUME (6) control,
10.BASS:
The BASS (10) control adjusts the relative level of the low
frequencies in the sound.
11.PHONE JACK: 1/4" headphone input jack (11).
12.MONO:
When the MONO (12) button is activated (LED is lit), the two
stereo channels are blended together to produce monophonic sound.
This blend minimizes rumble and surface noise in old monophonic
records, Push the button a second time (LED goes out) to get back to
stereo mode.
13.MUTE:
Pushing this button reduces the volume of the amplifier output
signal by approximately 20 dB. Pressing the button a second time
removes the muting. The MUTE (13) has no effect on the microphone
volume,
14.LOW CUT:
The output from a turntable usually contains strong but
inaudible impulses at infrasonic frequencies (below 20Hz) due to disc
warps, stylus/tonearm resonance,
and vibrations that reach the
turntable. if these are amplified at full strength, they may waste
amplifier power and muddy the sound. The LOW CUT FILTER (14)
attenuates these unwanted signals.
15.LOUDNESS:
When pressed, the LOUDNESS (15) button engages a
"loudness compensation" circuit which, at low-to-medium volume,
boosts the bass and treble response,
USING THE GROUND
LIFT SWITCH:
Depending on your system configuration, sometimes applying the
ground will create a quieter signal path. Sometimes lifting the ground
can eliminate ground loops and hum to create a quieter signal path.
1. With the unit on, listen to the system in idle mode (no signal present)
with the ground applied (the GROUND LIFT SWITCH (25) in the left
position).
2. Then turn the power off before moving the GROUND LIFT SWITCH
(25). Lift the ground by moving the GROUND LIFT SWITCH to the right,
turn the power back on and listen to determine which position will
provide a signal devoid of background noise and hum. Keep the
GROUND LIFT SWITCH in the ground position if the noise level remains
the same in either position.
SPECIFICATIONS:
INPUTS SENSITIVITYAMPEDANCE
Mic.
1mV/3 Kohms
mV /47 Kohms
150mV /3 Kohms
„max. 11V/1Kohms
Tape, Tuner,CD,
SIGNAL TO NO!
Mic.
ui
ISE
Tape, Tuner, CD, Aux.
GENERAL
„120V or 230V, 50/60Hz
Al
Weight...
GEMINIDI.COM
(3)
Publicité
