MESTIC MWC-200 Mode D'emploi page 7

First Use of the Machine
1. Before using the machine for the first time, water should be boiled in it twice without any additives.
2. Place the machine on a flat surface.
3. Fill the kettle with water. Do not overfill. Use the water level indicator.
4. Place the kettle flush on the base.
5. Electrical connection
1. Check whether the electrical voltage that you intend to use is the same as that of the machine. Details are to
be found on the label on the base.
2. Only connect the machine to a property installed 220-240V- 50/60 Hz safety socket.
6. Switch the machine on. The control lamp Indicator shows that the water is being boiled.
7. After boiling, the machine switches off automatically.
8. Disconnect the machine from the mains electricity supply.
9. Do not press up the lid when pouring.
Cleaning
1. Always remove the plug from the mains supply before cleaning the machine!
2. The exterior of the machine should be cleaned, if necessary, with slightly damp cloth additives.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means
that this product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or
dismantled to minimize its impact on the environment. For further information, please contact your local
or regional authorities. Electronic products not included in the selective sorting process are potentially
dangerous for the environment and human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MWC-200, applies all basic requirements and other relevant
regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive
(2014/35/EU). If you require a full declaration of conformity, you can contact the adress listed on the backside of this
manual.