Audizio 102.070 Manuel D'instructions page 9

• Start the record playing as described above, and press record at the top of the
Audacity window to start recording to the computer.
• Once recorded, use the Transport controls at the top of the screen to: Go to start,
Play, Record, Pause, Stop and Go to the end.
• Use the File, Edit, View, Project, Generate, to save, export
and edit your music.
• If the recording level requires to be adjusted, click on
'START', 'SETTINGS' and select 'Control Panel.' Under
Control Panel, select 'SOUNDS and AUDIO DEVICES', click
on the 'VOLUME' tab and select 'ADVANCED'.
• On the Master volume window, select options at the top
left hand corner, click on properties in the drop-down menu.
• In the Properties window, select "USB PnP Audio Device" from the drop-down menu at the top. Click "OK" to confirm the
Selection and a window will now appear with a control for the recording level. Move this control up if the recording is too
quiet and down if the recording is too loud.
NOTE: the blue wave form should sit in the Audacity window such that the peaks of it stop short of the top and bottom.
Before editing your music, the recorded waveform will need to be highlighted.
• To highlight your wave form, click with the left mouse button on the left hand side of the waveform (under the L+R controls)
and the waveform will go darker.
• At this point the whole waveform can be edited. The section required can be highlighted by placing the mouse over the
beginning of the section holding the left button down and dragging it right over the area required and releasing it when the
end of the desired section is reached. This darkened section will now be the only audio that will be edited.
• Alternatively click on the EDIT menu at the top left and click on SELECT, then choose from: All (whole wave form), Start to
Cursor or Cursor to end.
NOTE: after recording to the Computer, the USB cable may have to be removed from the USB port in order to enable playback
later from the computer.
• Once you have recorded and edited your music, you will need to save your files to the computer. To do this, click on file and
move down to Export as WAV tab.
• Click on this and you will promptly be asked for the file name of the music recorded which will be saved in the location
shown. At this point either make a note of the folder where your music is saved or save it in a folder of your choice.
• This can either be an existing one or a new folder.
• Once you have recorded and edited your music, you will need to save your files to the computer. To do this click on file and
move down to Export as Mp3 tab.
• Click on this and you will promptly be asked for the file name of the music recorded which will be saved in the location
shown. At this point either make at note of the folder where your music is saved or save it in a folder of your choice.
• This can be either an existing one or a new folder.
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment from them and to make them last.
We would also point out that for the same reason your stylus should be replaced periodically (approximately every 250 hours).
9