Evolite DWT-512 Mode D'emploi page 10

o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note
the starting address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and
connectors in order to connect the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
DWT-512 user guide Ver. 1.00 Page 10