Sony CFI-1115A Guide De Mise En Route page 2

Let's get started
1
Attach the base.
Always attach the base to the console, whether it's in the
vertical or horizontal position.
Place your console on a flat surface when attaching the
base.
You'll need to reconfigure the base for the position
of your console. Rotate the top and bottom part of
the base in opposite directions. Keep rotating until
you hear a "click".
For the vertical position
With the base attached
2
Make sure the hook is in the position
as illustrated below before attaching
the base to the console.
Hook
Place the console with the rear side facing up, and
1
then remove the screw hole cap.
Attach the screw hole cap to the bottom of the base.
2
Remove the screw from the bottom of the base.
3
Bottom of
2
base
Attach the base, and then secure with the screw using
4
your hand. You can also use a coin to tighten the
screw.
3
CFI-1115A 5-031-577-11(1)