Publicité
Les langues disponibles
Les langues disponibles
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING
cause serious and permanent respiratory or other injury. Always use NOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Symbols
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
...............Read instruction manual before use
................Use proper eye protection
BPM ............beats per minute
• When using an extension
cord, be sure to use one
heavy enough to carry the
current your product will
draw. An undersized cord
will cause a drop in line
voltage resulting in loss of
power and overheating.
The following table shows
the correct size to use
depending on cord length
and nameplate ampere
rating. If in doubt, use the
next heavier gauge. The
smaller the gauge number, the heavier the cord.
fUNcTIoNAl DeScRIPTIoN
figure A
1. Variable speed switch
2. Lock-on button
3. Forward/reverse slider
4. Two-gear selector
5. Drilling mode selector
6. Chuck
7. Chuck key & strap
8. Depth stop rod
9. Side handle
:
Use of this tool can generate and/or disperse dust, which may
volts
120V
240V
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More
Than
0
-
6
-
10 -
12 -
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
...................Use proper respiratory protection
................. Use proper hearing protection
Minimum Gauge for cord Sets
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
51-100
Not more
American Wire Gauge
Than
6
18
16
10
18
16
12
16
16
16
14
12
a
8
6
9
4
reciprocation per minute
Total length of cord in feet
51-100
101-200
16
14
14
Not Recommended
5
3
4
7
101-150
201-300
14
12
12
1
2
Publicité
