Using Side AV Connectors
You can connect a range of optional equipment to
your LCD TV..
•
For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
•
To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.
Using Other Connectors
You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
•
For connecting a to a device that has SPDIF support,
use an appropriate SPDIF cable to enable sound
connection.
Remote Control Handset
Inserting Batteries
•
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
AAA/R3 or equivalent type batteries
•
Insert two
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
•
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
•
To switch on the TV from standby mode either:
•
Press the "
button on the remote control.
•
Press the "
TV will then switch on.
Note: If you switch on your TV via CH
buttons on the remote control or on the TV set,
the programme that you were watching last will be
reselected.
By either method the TV will switch on.
To Switch the TV Off
•
Press the "
the "
" switch on the TV, so the TV will switch to
standby mode.
To power down the TV completely, unplug the
•
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
Digital Teletext (** for UK only)
• Press the "TXT" button.
•
The digital teletext information appears.
•
Operate it with the coloured buttons, cursor buttons and
OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on digital teletext
screen.
•
When Press "
on the screen, press the OK button.
•
When the "
television broadcasting.
•
With digital broadcasting (DVB-T-C), in addition to
digital teletext broadcasting together with the normal
broadcasting, there are also channels with just digital
teletext broadcasting.
•
The aspect ratio (picture shape) when watching
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.
•
When you press the "
teletext screen will be displayed.
English - 48 -
" button, CH
/ CH
" button, - or + button on the TV. The
" button on the remote control or press
OK" button or similar message appears
TXT" button is pressed, the TV returns to
TXT" button again, the digital
or a numeric
/ CH