Uline BUNN H-10275 Mode D'emploi

H-10275
BUNN POUROVER
®
2 BURNER COFFEE
MAKER WITH 2
DECANTERS
WARNING!
• Fill water tank before turning on thermostat or
connecting appliance to power source.
• Use only on a properly protected circuit
capable of the rated load.
• Electrically ground the chassis.
• Follow national/local electrical codes.
• Do not use near combustibles.
• Failure to comply risks equipment damage,
fire or shock hazard.
• Read the entire operating manual before using
this product.
• This appliance is heated whenever connected
to a power source.
CAUTION! The brewer must be disconnected
from the power source throughout the
initial setup, except when specified in the
instructions.
1. Insert an empty funnel into the funnel rails.
2. Place an empty dispenser under the funnel.
3. Open the flip lid on top of the brewer and pour in
three pitchers of tap water. Allow approximately two
minutes between pitchers for water to flow into the
tank. While the third pitcher of water is entering the
tank, the tank will fill to capacity and the excess will
flow from the sprayhead, out of the funnel and into
the dispenser. (See Figure 1)
PAGE 1 OF 6
1-800-295-5510
uline.com
SAFETY
ELECTRICAL REQUIREMENTS
The brewer has an attached cordset and requires
two-wire grounded service rated 120 volts AC, 15 amp,
single phase, 60 Hz.
INITIAL SETUP
Pour le français, consulter les pages 5-6.
WARNING! To reduce the risk of electric shock,
do not remove or open cover. No
user-serviceable parts inside. Authorized
service personnel only. Disconnect power
before servicing.
CAUTION! The brewer must be disconnected
from the power source until specified in Initial
Setup.
Figure 1
Funnel
Para Español, vea páginas 3-4.
Dispenser
0724 IH-10275