Publicité
Les langues disponibles
Les langues disponibles
1
Paste the 4 black gaskets(A) on the top of the base. The holes on the black gaskets(A)
should be aligned with the holes on the base to make them penetrate.
2
Install the 4 stainless steel screws(B) on the bottom of table top.
Lift up the table top, align the screw with the hole on the silicone gasket(A) of the base, slowly lower the
3
table top, pay attention to avoid the screw scratching the table top.
Put the stainless steel gasket(D) and Stainless steel spring(E) on the screw(B), and then lock it with the
4
Stainless steel nut(C).
Adjustable feet has pre-installed on the bottom of fire pit already. Please adjust the hight of
feet to make sure all fire pit was on level always, or increase the height of fire table as your
preference. Please make sure the height was safty before you complete.
FIREPIT
Place lava rock by hand. DO NOT dump bag out
into tray to avoid clogging the burner with dust.
Position the lava rock to a level about 1" above the
top of the burner. Make sure that you do not block
the igniter box with lava rock to ensure proper ignition.
Make sure the gas supply system is turned to "OFF".
Install the AAA battery as shown in the diagram below.
ASSEMBLY INSTRUCTIONS
B
A
D
E
C
FIREPIT
9 / 60
1
2
_
+
Publicité
