Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
8. Fit the bar flush against the mounting surface so that the bar studs are in the long
slot of the bar.
9. Aligned the clutch cover lock knob with the screwed bar stud and press the clutch
cover into the screwed bar stud (Fig.6).
Note: Ensure the adjusting pin in the clutch cover is in the bar chain tensioning pin hole.
10. Rotate clutch cover lock knob clockwise just enough to hold the bar in
position (Fig.7).
Note: The bar must be free to move for tension adjustment.
11. Remove all slack from the chain by rotating the chain tensioning knob clockwise
until the chain seats snugly against the bar with the drive links in the bar groove
(Fig.7).
12. Lift the tip of guide bar to check for sag. Release the tip of the guide bar and turn
the chain tensioning knob clockwise. Repeat this until the sag does not exist (Fig.8).
13. Hold the tip of the guide bar up and tighten the clutch cover lock knob securely
NOTE ! The chain is correctly tensioned when there is no sag on the underside of the
guide bar, the chain is snug, but it can be turned by hand without binding.
FUEL AND FUELING
WARNING
Always shut off engine before fueling. Never add fuel to a machine with
a running or hot engine. Move at least 10 ft. (3 m) from
refueling site before starting the engine. DO NOT SMOKE! Failure to
follow this warning could result in serious personal injury.
NOTE ! The chainsaw is equipped with a two-stroke engine and must always be run using a
gasoline and two-stroke oil mixture. It is important to accurately measure the amount of oil
mixed with gasoline to ensure the correct mixture. When small amounts of fuel are mixed, even
a small inaccuracy can dramatically affect the ratio of the mixture.
WARNING
Always ensure there is adequate ventilation when handling fuel.
DANGER
Fuel is very flammable. Use extreme care when mixing, storing or handling fuel
or serious personal injury may result.
30
S
4
5
6
7
8
Publicité
