Westinghouse WSnow23 Mode D'emploi page 16

TROUBLESHOOTING
PROBLEM
Snow blower won't
start
The motor is on but the
auger does not turn.
A layer of snow
remains on the ground
after passing over it.
POSSIBLE CAUSE
Snow blower is not plugged in.
The start button was not depressed.
The drive belt may be worn or broken.
The auger or scraper may be worn.
CORRECTION
Connect snow blower to 120V power
supply. Be sure the snow blower plug is
properly connected to the extension cord.
Press and hold the start button before
engaging the bale.
Replace the drive belt.
Have the auger or scraper replaced by an
authorized service center.
English
|
16