Publicité
Les langues disponibles
Les langues disponibles
3. Connection
Before starting
Download the application "Energeeks 3.0" on your
mobile phone; it is available on Google Play and APP
Store. For Wifi connection, the camera only supports
2.4GHz frequency, (does not support 5g), it is necessary
to connect the phone used for installation to the 2.4g
network (only during the installation process), once
installed the camera can use 5g again. If you prefer, it
also has rj45 connection to connect it via network cable.
Installation via Wi-Fi
•
Remove the cover at the base of the lamp, under the
cover is the memory card slot and a button to reset.
•
Connect the power and wait a few seconds for it to
start, press reset for 5 seconds to reset the camera
in connection mode, you will hear a beep, the camera
goes into connection mode and will indicate, "wait for
wifi config").
•
Connect your phone to the 2.4g network and open the
app "Energeeks 3.0"
•
Press the + sign at the top to add a new device and
select surveillance camera.
•
Enter the password for your 2.4g Wifi network and
press confirm.
•
Show the camera the QR code that appears on the
29
Publicité
