dinotec PREMIUM Guide D'installation, D'utilisation Et D'entretien page 45

I
Whatever the
direction of the cell, respect
the direction of the arrow on
the sleeve (circled below),
according to the direction of
passage of the water.
F A
A : Nut
B : Electrode
C : O-ring (internal Ø 68 mm)
D : Stopper
E : O-ring (internal Ø 18 mm)
F : Piping
1) Pass abrasive paper on all surfaces to be bonded : F-piping, G-restrictor, H-collar.
2) Slide each nut A onto each piping F.
3) Cut the 2 pins on each collar
4) Glue each set [ piping
5) Wait until the collages are completely dry.
6) Place each o-ring C on each collar H.
7) Attach the muff J to each piping
I
Screw and tighten the nuts
8) Fit the sets [ A - B - C
OTHER POSSIBLE INSTALLATION
Exploded view of the assembly :
mounting
D
E
G H C
G
H
J
K
H (circled in the picture opposite).
F - restrictor G - collar
F with the nuts A.
A by hand.
], [ C - K - A ] and [ D - E
A
B
C
J
E
D C
K
A
: Restrictor
(to be installed only if the
: Collar
: Muff
: Flabby
H ].
] on the muff J.
I
This installation :
- can not be carried out on
an already
pipeline ;
- can not be dismounted
once made (except the
sets [ A - B -
], and [ D - E
C H G A
F pipe has an outside diameter of 50 mm)
existing
C ], [ C - K - A
]).
F
14