AEG SK 150 Mode D'emploi page 14

14
aSSEMBLY
only install the windscreen de-icer if the vehicle has a 12-v on-board power
supply and the vehicle power socket is equipped with a minimum 15 a fuse.
Warning!
▪
Mortal danger! Do not mount the windscreen de-icer within the airbag
inflation area or in the head impact zone of people seated in the vehicle.
▪
Mortal danger! Do not mount the windscreen de-icer so that it impedes the
view of the driver in any way.
▪
Mortal danger! Do not mount the windscreen de-icer so that it can become
unattached during strong braking action or when negotiating tight curves.
▪
Danger of overheating! Select the mounting position so that the air inlet and
outlets cannot be blocked.
1. Select a suitable position in the vehicle to mount the unit and make sure that
it is dry and free from dust and fat.
2. Remove the protective foil from the hook-and-loop-fasteners and attach the
fasteners to the base of the holder.
3. Remove the other protective foil from the hook-and-loop-fasteners and
press the windscreen de-icer, together with the holder, onto the intended
mounting position.
4. Lay the connector cable to the 12-v vehicle socket. Lay it so that it does not
impede access to the pedals or steering wheel. Do not lay the cable over
sharp edges or hot areas.
You can also use the enclosed screws to affix the windscreen de-icer.
Make sure that you do not damage other cables or parts when you screw in
the screws or drill holes for them.