Create Studio Manuel D'instructions page 9

According to the different cooking requirements, the food will be processed differently and
the corresponding preparations will be made for each.
Put the ingredients in
the pot.
Schedule Setup
• When the product is turned on in standby mode, you can see on the digital display: "----".
• Press the [TIMER] button, if you want the delayed start. The digital display shows a default
time of 0:30 hours. Press the [TIMER] button again repeatedly to set the desired delay time.
Turn the command wheel, within 5 seconds, to choose the function you want.
• Select a function by pressing the Jog Wheel to enter the working mode or press the [CAN-
CEL] button in case you want to return to the standby mode.
• Once in work mode, pressing the [TIMER] button will have no effect.
• If delayed start has been set, the function indicator LED will flash until cooking starts.
When in cooking mode, the programme LED will be displayed steady.
• If you do not want a delayed start, turn the control knob to select the desired function and
press the knob to confirm the function. Cooking will start within a few moments.
• If you want to cancel the work mode and return to the standby mode, press the [CANCEL]
button.
Note
• Make sure the grid on the stainless steel lid matches the steam outlet.
• If the food goes bad easily or it's hot, don't set a long time.
• Product cooking time = Delayed start programming time [TIMER] + Working time of the
selected function. Example: It takes 2.5 hours to make soup. If you want to have the soup
ready in 7 hours, you should set the start programming time to 4.5 hours and select the
function for [SOUP], which takes 2.5 hours.
Status at the end of the firing program:
• Once the chosen program is completed, the product automatically goes into the thermal
insulation function. At this time, the heat insulation function indicator lights up, and the
digital display shows the countdown.
• Press "Cancel" key, the digital display will show "---", and the indicators of all functions will
stay on.
• During the working mode, if the water is insufficient or the product dries up, the indicators
of all functions light up, and the digital display shows a failure indicator.
MODE OF USE
Place the pot in the
machine body.
• 4,5h standby + 2,5h cooking time = 7h
Close the lid. Set the program
corresponding to the food you
are going to cook.
E NG L I SH
9