Home Decorators Collection HDC5977B1 Guide D'utilisation Et D'entretien page 6

Installation (continued)
4
Attaching the fixture body to the outlet box
□
Place the rubber washer (EE) over the Lock screw (DD).
□
Line up the holes on the backplate and mounting holes on
the folded edge of the crossbar assembly (AA).
□
Secure the fixture body (A) by threading the lock screws (DD)
into the mounting holes on the crossbar assembly (AA).
□
Thread one lock screw (DD) into the first side. Do not fully
tighten.
□
Thread the other lock screw (DD) into the other side and
tighten with a screwdriver.
□
Tighten the first lock screw (DD) with a screwdriver.
5
Installing the bulb
□
Remove the two mounting screws (2) and stem (1) from
the fixture body (A) and keep the stem (1) and two
mounting screws (2) for later use.
□
Install the correct bulb (not included) referring to the
fixture markings and/or labels for maximum wattage.
□
Secure the previously removed stem (1) with the
previously removed mounting screws (2).
NOTE: Use one 60W maximum medium base (E26)
type "S" or 8W maximum medium base (E26)
self-ballasted LED vintage Edison bulb (sold separately).
A
1
2
AA
DD
EE
6
Using silicone sealer
□
Make sure the surface of the exterior wall and the fixture
backplate are free of dirt.
□
Using silicone sealer (not included) start on one side of the
fixture backplate and follow the contour where the fixture
backplate meets the exterior wall surface.
□
Proceed to seal around backplate.
NOTE: To ensure proper moisture drainage, do not seal
bottom of fixture backplate.
6
DD
EE
A