CURRENTBODY skin LED LIP PERFECTOR Mode D'emploi page 4

LIGHT-SENSITIVITY TEST
Test yourself for light-sensitivity prior to initial treatment:
1. Power on your device.
2. Place device on the skin of your forearm for three minutes.
3. After 3 minutes, check the area. If area has turned red, and
redness lasts for more than 2 hours, your skin is light-sensitive.
4. If your skin is light-sensitive, return the device to
CurrentBody within 14 days for a full refund.
HOW TO USE
Set up:
1. Unpack your CURRENTBODY Skin™ Led Lip Perfector. There
are 2 ways to charge your device.
A. From the charging base:
- Place the Led Lip Perfector on the base, ensuring on either side
are in contact with the base.
- Plug the USB charging cord into the charging base.
- Plug the USB charging cord into a Universal USB Power
Adapter (not included) and then into a mains outlet.
B. By plugging the cord directly into the device and then into a
Universal USB Power Adapter (not included). Plug the adapter
into a mains outlet.
5
2. The power indicator light will flash while charging. Charge
your device for 1.5 - 2 hours. The device is fully charged when
the power indicator light is solid (not flashing). The USB port can
be found under the mouthguard. Simply remove and plug in.
3. Place the device in the protective (no gap) storage bag when
not in use.
4. Ensure you unplug the device from the USB charger before
using. For your safety, this device will not work when it is
charging.
5. When the charge is low the indicator light will flash. To
recharge the device, follow the instructions above.
Treatment:
1. To use the device, ensure the silicone mouth tray is clean and
attach to the device.
2. Place the tray in your mouth so the device is comfortably
against your lips.
3. Switch ON. The device will automatically switch off after 3
minutes.
4. You can switch the device off at any time by pressing the ON /
OFF button
5. For best results, use daily.
6