Bumper Bar - EasyWalker SKY Mode D'emploi

5­point harness
WARNING: Always use the 5­point harness when carrying your child in the seat.
!
! WARNING: Always use the crotch strap in combination with the waist strap when putting
your child in the 5­point harness.
The EasyWalker SKY seat is supplied, as standard, with the shoulder straps in the highest
position. You can set the shoulder straps to a lower position, so that smaller children
are seated more comfortably (image 12). To do this, click the shoulder straps to release
them from the crotch strap and take the shoulder pads off. Open the zip at the top of the
back support. You can now take the shoulder strap through one of the other openings.
Click the shoulder strap back onto the crotch strap and shut the zip at the top of the back
support.
The EasyWalker SKY seat is supplied, as standard, with the waist strap in the smallest
position. You can set the waist strap to a larger position so that larger children can be
seated more comfortably (image 13). To do this, take the waist strap out of the loop on
the base of the seat.
You can use the sliding buckles to make the shoulder, hip and waist straps tighter or
looser (image 14).
TIP: The tapes on the rear of the seat that go around the frame, just above the rear
suspension, are part of the harness and provide extra comfort and security for your child.
Ensure that these are always closed around the frame.
Sun canopy
In order to attach the sun canopy place it, with open attachment clips, inside the upper
recess in the seat fabric, exactly between the two caps on the inside of the frame (image 15).
To remove the sun canopy click and release the attachment clip on the sun canopy on
both sides of the push­bar. You can now remove the sun canopy from the frame.
TIP: Give yourself enough space. Before assembling or dismantling, release the poppers
around the recess in the seat fabric.
IMPORTANT: After assembly shut all poppers again.
IMPORTANT: A small child has very sensitive skin. Never leave your child in the
EasyWalker SKY in the sun without the sun canopy on.
Bumper bar
Place the bumper bar with opened clips on the frame in the lower recesses in the seat
fabric and shut both clips (image 16+17). To remove the bumper bar, open the clips and
remove the bumper bar from the frame.
TIP: Give yourself enough space. Before assembling or dismantling, release the poppers
around the recess in the seat fabric.
IMPORTANT: Before use always check whether the bumper bar is securely fixed to the
frame.
IMPORTANT: After assembly shut all poppers again.
EN­18