Johnson JDRY8B Guide D'utilisation page 54

MAINTENANCE
Problem
•Display is not
on
• " "is
lighting
•" •" "is lighting
•Dryer does not
start
•Degree of dryness was
not reached or drying
time too long
•There are humming
noises
•The dryer switches off
at the end of the
programme
Warning!
！
If you cannot deal with the problems by yourself and need help:
• Press the On/Off button.
• Pull out the mains plug and call the service.
Solution
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the On/Off button.
• Check the water container. If it's full, please pour
out the condensate water and restart the dryer.
• If the container is not full, please restart the dryer
directly.
• If the " " icon is still lighting after you have
finished the first two steps, please call the service.
• Clean the lint filter.
Connect the tumble dryer to the mains.
•
• Turn on the tumble dryer.
Check the the door is closed.
•
• Check the programme is set.
• Press the Iniciar/Pausar button.
• Clean lint filter and heat exchanger.
• Empty the water container.
• Check the drain hose.
• Check installation place is appropriate.
• Keep the air inlet clean.
• Use higher drying intensity level
programme or time programme.
• The compressor is operating. These noises are
quite normal and do not indicate a fault.
• The dryer switches off automatically for
energy saving. This is not an error but a
normal function.
26
V.1